09-11-2008 8:08 PM
I'm new to Flex Builder and I'm trying to install it into NWDS CE version and keep getting an error.
Is there a trick to this? Some instructions would be helpful.
Thanks,
Cindy
09-23-2008 10:34 AM
Hi,
Install FlexBuilder,
install NWDS CE version,
Then, copy the $FLEX_HOME/plugins and $FLEX_HOME/features into NWDS_HOME/plugins and $NWDS_HOME/features
there will be conflicts while copying plugins but dont replace existing one say no for replacement.
edit $FLEX_HOME/configuration/config.ini copy and paste the same in $NWDS_HOME/eclipse/configuration/config.ini .
Regards,
Sandeep.
09-23-2008 5:52 PM
Depending on the entries I copy into the config.ini it either doesn't load up NWDS at all (stops with no error or anything) or it logs an error.
If I put in all the Flex config entries into the NWDS config.ini, it errors out. If I only add the items (keys) that are not in the NWDS config.ini, it dies without any errors. If I leave the NWDS conifg.ini as it was, it logs errors.
Now my NWDS will not open at all.
Any ideas?
Thanks,
Cindy