Repetitive Manufacturing

[Former Member]

Hi,

Is there a place where i can see the status of the planned orders in repetitive manufacturing to check whether is confirmation is done or not.

[Former Member]

No,

In REM...planned order is just a qty representation and cannot control any thing with planned order. Without planned order also we can do the backflush...hence there is no way you can see the status of planned order.

If you want to have a control with planned order, then make sure that you control the consumpotion of planned oder...follow the procedure in MFBF as below

In MFBF enter the plant and material, then in the selection subpage, serach for the planned order by pressing F4...in the range select the planned order after sorting on the way you want...this is the only way you can see that which plannde order is getting consumed against the MFBF,

If you want you can enter this planned order in dec header text for information.

[Former Member]

actually, can use user exist to control(without planned order can not backflush)

regards.

[former_member335796]

Hi,

There is no place to check the Backflushed planned orders..

If the backflush is don fully, then the planned order will not be available in the System.

If the backflush is partial (means 100 is the pl. order qty, you did say 80 PC), then in the planned ordr component view you can see the withdrawn qty.

Regards,

Siva

[Former Member]

Thanks folks it was really helpfull.