on 09-11-2008 1:17 PM
All
I am facing some issue in customizing. Batch level is client.
When try to configure SLED check via OMJ5, i am not able to see the plant which i had created recently. Did i miss any config step which was required to be done before this.
Regards
TOM
Hi,
Check in SPRO > MM > Inventory Management and Physical Inventory > Plant Parameters > here your Plant exists or not? If not then maintain it first and then check in OMJ5
To maintain Plant parameters, copy it from the Plant 0001 to your Plant.
Note: - It happens generally if you don't copy Plant, when you create it manually. SAP suggests to copy Plant from the existing one or from SAP standard Plant.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You need to copy the plant from EC02 ( This will allow you to copy all the dependent entries in the system for the standard SAP Plant 0001)
If you copy the plant from OX10, this wont copy anything except the plant address.
Copy the Plant with EC02 and then change the address with OX10 and you should be able to do OMJ5
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.