on 09-09-2008 7:57 PM
Hi ,
Is there any report to delete the entries in ERT table. (Cluster B1).
Thanks.
Regards,
Raj
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Sorry, we have the same problem. Has a solution been found yet? Thanks in advance!
Florian
Hi,
You can use the following reports to delete the Clusters.
RPUP1D00 - to delete single entries in PCL1
RPUP1D10 - to delete a set of entries in PCL1
RPUP2D00 - to delete single entries in PCL2
RPUP2D10 - to delete single entries in PCL2
In our case,
We had run Time eval again and then we deleted the B1 Cluster using RPUP1D00.
Hope this helps.
May I know the requirement as to why you need to delete the table entries?
This table will contain messages from the last evaluation run. These messages comes from table V_T555E.
Thanks,
We have been getting the following error when running the report
RPTERR00.
"Internal error: No entry in table PTAB on 05/28/2008 for personnel
number xxxxx"
This is because the employee had been initially hired on 05/28/2008
and later the hire date was changed to 06/02/2008 on 06/04/2008.
Time Eval is done daily and so for the period 05/28 - 06/01 time eval
had been run and this had populated the ERT table with error type - 1
for the period (05/28-06/01)
In order to correct this we had to delete the B1 cluster entries from
05/28/2008 to 06/01/2008.
But even after deleting the B1 Cluster entries using report - RPUP1D00
we were getting the same error.
On analysis , we found that there are entries still in the ERT table in
B1 Cluster.
Is there any Report / work around to delete the entries in the ERT
Table?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.