How to select a request ID in DTP.

[Former Member]

Hi,

I have the necessity to load data from an Infocube A to an InfoCube B via DTP but using a selection only for REQUEST ID of the cube A. It is possible? If yes, in which way? I do not find a valid field in DTP->Filter->Change Selection for selecting data related to a request number created for InfoCube A.

Any suggestion will be well appreciated.

Thanks in advance.

Regards,

Giovanni

[Former Member · Accepted solution]

It is not possible to load a specific request from the source using a DTP, either load it request by request or set up some criteria in the filter or run fake DTP's.

Elaborate your requirement inorder for us to better assist.

[Former Member · Accepted solution]

Beekay,

We have to load only one request from an ODS into the cube. We are in version 3.5. Is this doable in 3.5? If yes, Please let me know the procedure.

[former_member207028]

Hi,

Data Can be loaded based on Reqest ID.

while loading data from Infocude A to Infocube B through DTP, you have to select option load data by Request in DTP Extraction tab. then data will be loaded based on request.

hope this helps

Regards

Daya Sagar