Problem with SQ10 assigning user group to role

[former_member258552]

Used SQ10 to assign user-group to a role and then assigned the role to a user. When the user runs a query, it shows that no user-group has been assigned.

Can user groups be assigned to roles?

Is there any setting that is required for SQ10 to work?

Edited by: Yong Qiang Zhao on Sep 8, 2008 7:07 AM

Edited by: Yong Qiang Zhao on Sep 8, 2008 7:09 AM

[former_member337345]

Hi Yo!

you need to assing the users to the User Group using Tcode:SQ03

hope it solve your issue. else reply me back.

Thanks & Regards

Sunil Kondoju

[former_member258552]

Hello Sunil,

The problem is that I have hundreds of users to maintain user groups.

found out that it is possible to assign user group to role and role to user groups. implementing hr authorization with in-direct assignment of auth. So if I could use sq10, user groups could also be link to position in the org chart.

sq10 does allow you to assign a user group to a role but when you assign the role to a user and the user runs a query, it reports that no user group has been assigned.

Suspect that there must be a parameter or switch that is not turned on

Regards