on 09-06-2008 5:53 AM
Dear Experts,
We have repeatitive manufacturing Scenario & during backflushing REPRO is allowed.
Now we want to stop REPRO so that booking (MFBF) can not be dode if any component is in error (Non REPRO Allowed).
What necessary steps/precautions has to be taken?
Should be create new REM profile
OR
We should use existing REM profile by removing the tick from Error correctionfor backflushing (create cumulative post processing record & also create individul post processing record) from existing REM profile.
What else to be done for costing/product cost controller which has already been done with existing Repro allowed profile?
Abhishek Dwivedi
Hi,
It is always better to create new REM Profile.
Apart from removing the Tick for Error correctionfor backflushing (create cumulative post processing record & also create individul post processing record), you need to set the tick for
Execute correction in Dialog Mode - Mandatory.
Now when ever there is a component missing system will pop up a message, if you process that message then ok otherwise system will not allow you to proceed further..
This is enough to restrict reprocessing/post processing.
I hope you are executing the Program: CORUPROC as a backhround job.
If not start executing thi program, every 30min or every 1 hr, with the setting error in goods movements.
Hope this helps..
Regards,
Siva
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Other than this nothing is required. System will take care of the Process.
As suggested execute the Program : CORUPROC periodically.
Some errors which are beyod our control may some times go and sit in COGI. This is eventhough we have restricted the REPRO, for this type of exceptions, we need to execute the above program..
Regards,
Siva
User | Count |
---|---|
89 | |
7 | |
6 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.