How to Conifg to control production order receipt qty according to bom qty?

[Former Member]

Dear All

I have a problem in the MIGO production order receipt. I want to according to BOM rate issue Component qty to receipt production qty.for example:

Production order : 5020001 plan qty 50

Component : A1 BOM qty 50

A2 BOM qty 100

If A1 and A2 have not issue then canu2019t receipt 5020001.

If A1 issue 1 qty and A2 issue 2 qty ,then 5020001 can receipt 1 qty.not allow than 1.

How can I set config,or MIGO have some user-exit to control?

Thanks.

Sun

[muthusamy_sankaran · Accepted solution]

Hi,

There is no simple way out for this problem, but you can set below any one of ways 1) user-exit 2) BADI 3) user status

Rather you can write an ABAP program for the same in exit CONFPP03 so that it will restrict confirmation of header material, or use CONFPP02 for checking the confirmation of child parts according to BOM before confirmation of Header Material.

pls refer below link

Regards,

Sankaran

[Former Member · Accepted solution]

Thanks a lot.

Sun