on 09-03-2008 3:28 PM
Hi
I have a 3 page smartform, all set up as DINA4 Landscape. The first two pages print duplex and then the third page can repeat and prints simplex. When I view the spool request in SAP all the pages look right, but when I output to the printer the first and second page are duplex and landscape (correct) but the third gets printed in portrait. I suspect something to do with the actual printer print controls but I'm not sure. Any ideas/advice?
Regards
Glenn
Hi
Check the print mode in your smartform i.e
For Each Page->Outputoptions>Printmode.
Regards,
Sravanthi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Did you checked out the Output options for each page for the page format.
Regards,
Venkatesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
The problem hasn't gone yet but it does seem to be caused by the device driver. When I print using LOCL the orientation on the last page goes wrong. But when I print using the defined printer device type in SAP (same printer, different driver) the orientation is correct but the fonts, etc go all pear shaped.
Basis are currently testing out a few different drivers.
Regards
Glenn
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.