SXMB_MONI: why is node with message after mapping not visible?

[Former Member]

Hi,

I'm working with XI 3.0 SP 20.

On our QA system i can see much more message nodes in sxmb_moni:

XML Message

- Inbound Message

- Receiver Identification

- Interface Determination

- Receiver Grouping

- Message Branch According to Receiver List

- Request Message Mapping

- Techn. Routing

...

inside the bold marked node i can see the message after mapping. On our development box i can only see 3 nodes:

XML Message

- Inbound Message

- Receiver Grouping

- Response

that's all.

Does anyone know how i can make all those other nodes visible? I need to inspect the message after the mapping (node Request Message Mapping)

regards,

ms

[agasthuri_doss · Accepted solution]

Hi,

This is because of Setting done in SXMB_ADM ,The Basis team will help you to resolve the issue

Cheers

Agasthuri Doss

[Former Member · Accepted solution]

Hi,

yeah ... but i'm the basis team

Does anyone knows how this is configured in sxmb_adm?

regards,

ms

[Former Member · Accepted solution]

Please check the blog i have send in my earlier reply

Aamir

[Former Member · Accepted solution]

Hi,

synchronous messages are already displayed. But there are some nodes missing. TRACE level is 3

regards

ms

[Former Member · Accepted solution]

Hey

In addition to TRACE,you need to set the following Parameters to 1 as well in sxmb_adm.

RUNTIME->LOGGING

RUNTIME->LOGGING_PROPAGATION

RUNTIME->LOGGING_SYNC

Thanx

Aamir

[Former Member · Accepted solution]

RUNTIME->LOGGING

was it. Tha parameter was set to 0 before.

Thanks a lot.

[Former Member]

Hey

If this is a synchronous scenario then you might wanna check settings in sxmb_adm

Thanx

Aamir