on 09-02-2008 12:34 PM
Hi All,
I got this error message. What should i do? I try to check my allocation structure...but it seem correct.
Complete allocation structure Z3
Message no. KD503
Diagnosis
During settlement, the system puts the sender debits into groups (assignments), which are settled using the same settlement cost element. The settlement assignment is made in the allocation structure, which is stored in the settlement rule for the sender (under settlement parameters).
Cost element 901000 cannot be assigned to a settlement cost assignment in allocation structure Z3, and therefore it cannot be assigned to a settlement cost element.
Procedure
Possible solutions are as follows:
If the posting under cost element 901000 was made to the sender because of an incorrect entry, and you can reverse the posting, and do not need to update the allocation structure. You only need to reverse the incorrectly assigned posting before repeating the settlement. Exception: For an investment measure with a line item settlement, you need to extend the allocation structure, even after the reversal.
If the posting was made correctly, you can do the following:
a) You can assign a different allocation structure to the sender: In the master data maintenance for the sender, choose "Settlement rule -> Goto -> Settlement parameters" and then enter a different allocation structure.
If necessary, also check whether the correct allocation structure is entered in the settlement profile. The allocation structure is defaulted in the settlement profile when you create sender master data or when you maintain the settlement rule.
You can update allocation structure Z3
Hi!
If you can tell more about settings that you have maintained in the settlement profile, it would be easier to provide proper solutuion.
Regards,
Seemant
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Settlement profile : ZPS001
GL, CC, Order, WBSE and FXA optional
Document type : SA (GL Account doc)
Distribution rule : 10
Residence time : 24
Allocation strucutre Z3
Default object type : FXA
tick on % settlement and equivalence no
to be settled in full
Allocation structure : Z3
Assignment : 1.Labour ,2.MAterial, 3. Subcontract
Source : 1. PSlabour , 2.PSmaterial 3. PSsubcon
Settlement cost center : FXA (ticl by CE), CTR (settlement cost element 90200) ; ORD (Settlement cost element 902001); GL(tick by CE)
Cheers,
Nies
Hi Sreenivas ,
The accounting document looks weird :
Hi,
Settlement profile : ZPS001
GL, CC, Order, WBSE and FXA optional
Document type : SA (GL Account doc)
Distribution rule : 10
Residence time : 24
Allocation strucutre Z3
Default object type : FXA
tick on % settlement and equivalence no
to be settled in full
Allocation structure : Z3
Assignment : 1.Labour ,2.MAterial, 3. Subcontract
Source : 1. PSlabour , 2.PSmaterial 3. PSsubcon 4.Cost
Settlement cost center : FXA (ticl by CE), CTR (settlement cost element 90200) ; ORD (Settlement cost element 902001); GL put 747100f
I already successfully settle from WBS to GL 747100(settlement receiver) However, when i check FB03 it shows that
GL account 747100
Posting key 40
Amount 25000
GL Account 747100
Posting key 50
Amount -25000
What the problem ?
Cheers,
Nies
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.