RFC Connection Error (for end-to-end Monitoring)

[Former Member]

Hi,

I am configure End-to-End monitoring in XI 3.0 SP20, PMI does't show data in end-to-end monitoring... anyway!!! I check RFC connection PMI

RFC destination name: PMIXQA90020080827

in TEST connection I am getting an error: "Group PUBLIC not Found" where may I define that PUBLIC to solve this problem please let me know.... thanks

and what is Group PUBLIC in RFC ??? what does it do???

Is there any notes I can read for related issue, please help me out this

Thanks a lot in advanced

Edited by: issue2008 issue on Aug 28, 2008 10:03 AM

[Former Member · Accepted solution]

Hi,

CAn you please tell what type of RFC connection is that ?

Regards,

Sharath

[Former Member · Accepted solution]

Thanks for reply... SURE I can tell you

Connection Type: 3 R/3 connection

ScreenShot shows blow:

http://www.flickr.com/photos/25222280@N03/2806290586/sizes/o/

Thanks

Edited by: issue2008 issue on Aug 28, 2008 10:20 AM

[Former Member · Accepted solution]

Hi,

Please check whether the IP mentioned is correct or check whether the Logon information is correct.

Regards,

Sharath

[Former Member · Accepted solution]

Yes, IP address is ok, even I tried hostname as well, as you look at it screenshot, getting an error: Group: PUBLIC does not found

what does it mein that? do i need to create some group for PUBLIC ???? it out of my mind

XIRWBUSER I am not sure what is password! its not dialog user its service user

do you have some other idea please reply me

Thanks

[Former Member · Accepted solution]

Hi,

I hope check the target system settings load balancing as NO.

Now you mention the IP or Host . I think it automatically picks the group once you mention the Host name or IP.

Regards,

Sharath

[Former Member · Accepted solution]

YES, you are right

I treid SMLG its shows logon group empty nothing there...

Instance name shows there

and status is GREEN

nothing else...

when I double click on it.... it asking me group name... I am not sure should I put group public ?

Thanks

[Former Member · Accepted solution]

Hi,

Have you checked the load balancing as No then it wont ask for group.

Regards,

Sharath

[Former Member · Accepted solution]

Sorry, I didn't check that... could you please tell me how to do that ??? and what I suppose to check there ?

but, in SMLG (CCMS Maintain Logon Groups) was empty as i told you before, I simple put logon group "PUBLIC" and test connection again now its does working fine... now error

after that then I goto RWB through web, and click end-to-end monitoring getting an Java error, the group I added does it efect some where ???

please advised

thanks again

[Former Member · Accepted solution]

Hi, Guys

PROBLEM IS RESOLVED!

SIMPLE GOTO SMLG AND ADD GROUP (PUBLIC)

RFC CONNECTION WORKS FINE...

THANKS YOU GUYS HELP