03 Data passed to port OK

[Former Member]

If we get the status of 03 Data passed to port OK from R3..can that be recived by XI.

i mean outbuntd idoc from R3...

[VijayKonam · Accepted solution]

Yes. If IDX5 is configured already.

VJ

[Former Member · Accepted solution]

then,what would would be the case if it not received by XI....what might be the fault....

If we get the status of 03 Data passed to port OK from R3..can that be recived by XI.

i havent received the idoc oin XI,what are all the Status codes,which can say,it can be taken by XI.....

Edited by: PSRK on Aug 18, 2008 2:23 PM

[VijayKonam · Accepted solution]

Read Help for configuring IDoc or search for some useful blogs! You will come across all problems and their solutions too..!!

VJ

[agasthuri_doss · Accepted solution]

Hi,

1) Check the PORT - IDX1

2) RFC Destination - SM59

3) Try to relaod the meta data - IDX2

Cheers

Agasthuri Doss

[Former Member · Accepted solution]

Sorry Doss,

it actually said

Status 30 IDoc ready for dispatch (ALE service) and status code 01 Idoc genrated in R3 system......from R3 side still it shows yellow...

does that mean Idoc will reach XI....

[agasthuri_doss · Accepted solution]

Hi,

>Status 30 IDoc ready for dispatch (ALE service) and status code 01 Idoc genrated in R3 system......from >R3 side still it shows yellow...does that mean Idoc will reach XI....

The IDOC not reached XI, check the partner profile, ports, process code, distribution channel

Cheers

Agasthuri Doss

[agasthuri_doss · Accepted solution]

Hi,

Go thru the below url

http://help.sap.com/saphelp_nw04/helpdata/en/52/16adef543311d1891c0000e8322f96/frameset.htm

IDoc status 30: The IDoc is not transferred to the asynchronous RFC

Although the partner profile is defined and the IDoc has been constructed, the IDoc cannot be transferred to the asynchronous RFC. The IDoc is not sent, and there is no official entry in the RFC valuation (/nSM58) for the relevant subsystem.

You trigger transmission of the IDoc using report RSEOUT00. To start the report manually, choose Tools ® Business Communication ® IDoc Basis ® Test ® Outbound Processing from IDoc (/nWE14), or schedule a regular job in background processing for this report.

Check the outbound processing mode for the IDoc in the partner profile.

Outbound processing mode 2: The system sends the IDoc immediately

Outbound processing mode 4: The system collects IDocs that have been created and sends them in packets of a predefined size.

IDocs are not intended to be sent directly.

Status 30 in the IDoc can normally only occur if outbound mode is set to 4.

Cheers

Agasthuri Doss