cancel
Showing results for 
Search instead for 
Did you mean: 

RFC takes long time to reach to test

Former Member
0 Kudos

Hi,

i have issue related to RFC connection from BW to R3 systems

if i tried to test the connection it takes long time to respond

the result as following:

Logon 32779 msec

Transfer of 0 KB 1 msec

Transfer of 10 KB 2 msec

Transfer of 20 KB 3 msec

Transfer of 30 KB 4 msec

and if i tried after that to do the same test again it works fine

and the result as following

Logon 8 msec

Transfer of 0 KB 1 msec

Transfer of 10 KB 2 msec

Transfer of 20 KB 3 msec

Transfer of 30 KB 4 msec

So can you please tell me why it takes too long time to logon first time?

from the OS level i can ping the target system with out any problems.

Thanks

SE...

Edited by: Sherif Eid on Aug 17, 2008 4:33 PM

Accepted Solutions (0)

Answers (2)

Answers (2)

Former Member
0 Kudos

probably

1.Check both the systems are on same domain.

2.Check in your SM59 ,you have mentioned gateway and gateway host .if yes try to remove and check else revert back

3.under special options check slow rfc connection if it is already checked try to unchecked and if not try to check it.

4.Is the background user aleremote for BW-R3 connectivity?If not can you check the user and it's roles?

5.attach the routetrace from BW server to R3 and see how long does it take fto reach there first time and second time and see the difference?

Good Luck.

Thanks

Amit

JPReyes
Active Contributor
0 Kudos

Have you tried to use the IP Address instead of the host... it mitght be a DNS issue.

Regards

Juan

Former Member
0 Kudos

Hi ,

i'm using the IP during the creation of the RFC

and also i added the hostname of the target at the Hosts file.

Thanks

Former Member
0 Kudos

Any one can advice?