on 08-11-2008 8:55 AM
Dear All,
I just create a client and abt to do a client copy. But started the test run( resource) and still it is processing??
checked the st02 and was amaze to see all swaps happening.
ametab (NTAB) 0
Table definition 63,95 6.798 20.000 0
Table definition 63,95 6.798 20.000 151.073 175.109
Field definition 55,18 31.563 710 2,37 20.000 8.852 44,26 172.240 183.861
Short NTAB 97,78 3.625 2.590 86,33 5.000 3.078 61,56 0 1.922
Initial records 5,40 6.625 5.385 89,75 5.000 838 16,76 153.206 157.368
0
Program 71,21 150.000 4 37.500 8.715 23,24 151.329 540.342
In RZ10 the instance profile has the following value set.
ABAP Programs 150000 KB
Nametab 45272 KB
Generic key tables 29297 KB
Single key tables 10000 KB
CUA Information 3000 KB
Screens 4297 KB
Need to increase the parameter of the instance profile.
So should I have to add
rsdb/ntab/entrycount
rsdb/ntab/irbdsize:
rsdb/ntab/ftabsize
for increasing the size of buffer? or from oracle??
further to my reply.
You may need to run sappfpar check pf=/sapmnt/SID/profile/<instance profile> .
You should run it after setting the parameters in the instancae profile and adjust the shared memory parameter also.Then restart the system.
Good Luck
Amit
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Prashant
As much I could understand from your posting is that
1.Your system has default values and that is why these are not set in instance or default profile.
2.You can check all those parameters in rz11 and understand the meaning of each parameters.
3.Later whatever parameters you want to set in instance profile with rz10 .Please configure them in instance profile then save them.
4.To activate these parameters ,you need to restart sap and sometimes db and sap both.
Hope it help you.
Amit Asthana
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
checked the note 16244
But again, in instance profile those parameter are not added. The parameter can be view in st02--> double click on the Table definition( in red) and current parameter. You will see the actual value allocated.
Are this value set by SAP during installation? Now to change those parameter, do I need to add those parameter manually in rz10--> instance profile???
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.